41 12 557 Replacing luggage compartment floor, middle (tail panel removed)
WARNING: This page is about a different variant/trim than selected.
NOTE:
Owing to the different engine variants and equipment specifications, not all the components are taken into consideration.
The following list essentially represents the disassembly sequence.
- Remove cross member trim panel via rear axle support
Release nuts and remove heat shield (1).
Release grommets (2).
Release the wiring harness at the attachment points (3) and tie it to the side.
Installation note:
Make sure the grommets are installed correctly. (watertightness).
Release screw (1) and remove exhaust bracket.
Tightening torque 18 20 2AZ .