41 51 080 Removing and installing left or right front door: Notes

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Do not damage adjoining body components.

The graphics are schematic representations and are to be applied to the relevant vehicle type.

Open door.

Removal:

Pull the lock (1) up and disconnect plug connection.

Fig 1: Pulling Lock

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Secure door against closing.

Release screw (2) on door stop.

Open door up to limit position.

Release screws between both hinge elements at top and bottom.

Unhinge door by moving upwards and placing it on a suitable surface.

Fig 2: Hinge Screws

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: If door is being replaced: see NOTES ON REPLACING THE DOOR

Installation:

Attach door and tighten down screws.

Tightening torque 41 51 1AZ .

Fig 3: Hinge Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Open door up to stop and secure it against falling shut.

Connect the connector (1).

Join door stop and tighten down with screw (2).

Tightening torque 51 21 2AZ .

Installation note:

If necessary, ADJUST the door.

Fig 4: Connector And Screw

Courtesy of BMW OF NORTH AMERICA, INC.