Opening bonded connections
WARNING: This page is about a different variant/trim than selected.
- Opening spot-welded adhesive joint:
Open WELDING SPOTS .
WARNING: Draw off vapor and gases!Use personal protective clothing/equipment.
Heat connecting flange with a hot air blower. Heat components to max. 250 °C object temperature.
Release connecting flange with chisel.
Remove adhesive residue from connecting flange.
- Opening bonded connections:
Release any RIVET CONNECTIONS .
Roughly cut out damaged component.
WARNING: Draw off vapor and gases!Use personal protective clothing/equipment.
Heat adhesive flange with a hot air blower. Heat components to max. 250 °C object temperature.
The component can be peeled with the aid of pliers. Do not damage adjacent components.
Remove adhesive residue from connecting flange.
- Opening bonded connections on aluminum roofs:
Procedure is described in detailed in the relevant repair instructions.