Overview of additional work for the removal and installation or replacement of electronic components in the body area/windshield
WARNING: This page is about a different variant/trim than selected.
| Component | Removal and installation Calibration/Initialization required (diagnostic system must be connected) | Removal and installation Use of the Special tool necessary | Replacement Programming/coding Calibration/Initialization required (diagnostic system must be connected) | Replacement Use of the Special tool necessary | Remarks |
|---|---|---|---|---|---|
| Front section: (including bumper cover) | |||||
| Park Distance Control ultrasonic sensor | No | No | No | No | |
| Parking Maneuvering Assistant ultrasonic sensor | No | No | No | No | |
| Active pedestrian protection sensor | No | No | No | No | Must be replaced after the active pedestrian protection has been activated! Impact absorber must also be replaced! |
| Active pedestrian protection actuator | No | No | No | No | Must be replaced after the active pedestrian protection has been activated! |
| Rear area: (including bumper cover): |
|||||
| Rear view camera | No | No | Yes | No | |
| Park Distance Control ultrasonic sensor | No | No | No | No | |
| Windshield: | |||||
| KAFAS camera | no* | No | no* | No | *Necessary after replacement of the windshield |
| Camera-based driver support systems camera (F60 only) | no* | No | Yes | No | *Necessary after replacement of the windshield |
| RAIN SENSOR |