REPLACEMENT PART 1 OF 6 - Peeling off the faulty rubber seal
WARNING: This page is about a different variant/trim than selected.
Special tool required:
- Remove bonded connection with fingers or cleaning agent liner 00 9 327 .
- Overstretch gasket below an angle of maximum 20° very slowly under even tensile stress.
If the gasket is detached too quickly, the adhesive tape can tear off and remain on the painted surface.
The adhesive tape remaining on the painted surface must be removed with high cleaning costs.
NOTE:
When the adhesive tape separates from the gasket, the adhesive tape remaining on the paint must be fully separated at one location by approx. 10 mm until it is easy to grip.
Detach the adhesive tape by pulling strongly at an angle of approx. 20°.
When existing gaskets are being peeled off with a hot air blower: Do not damage paintwork.