REPAIR PART 1 OF 3 - Clean faulty areas
WARNING: This page is about a different variant/trim than selected.
NOTE:
A partially released bonding (rubber component, adhesive tape or adhesive tape paint) up to 120 mm may be finished.
A partially released bonding (rubber component, adhesive tape or adhesive tape paint) above 120 mm may not be finished. Gasket must be replaced.
- Release adhesive area of paint side from recesses and degrease with CLEANING AGENT R2 . Stick to air drying time > of 1 minute. Never use paint thinner.
- This will usually partially destroy intact edge adhesive areas.
- When removing, it is important to wipe off the adhesive area of the adhesive tape with a lint-free disposable cloth. (e.g. blue Kimtex)
- Carefully wipe off the adhesive areas.
Use necessary cotton- or fluff-free paper towel once only.
Do not touch the adhesive area after cleaning.