Handling Rubber Seal Profiles
WARNING: This page is about a different variant/trim than selected.
- If seals reveal partly detached protective film on delivery, they must not be bonded.
- Store seals at 5 °C to 40 °C.
- If, during the handling, the protective film has come off before bonding, it can still be bonded.
- Bonding at room and object temperature 25° ±5° C. Temperatures between 40 and 50 °C significantly increase initial adhesion.
- Seals, which are subjected to temperatures above 80 °C after bonding, will be very difficult to remove.
- Maximum storage time for replacement: see identification of the expiry date on packaging