51 33 000 Remove and install (replace) the power window regulator in the left or right front door

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Removal:

Unfasten plug connection (1) and disconnect.

Loosen the cable from the holder (2).

Loosen the nuts (3) and remove the power window (4) from the door.

Fig 1: Power Window, Plug Connection, Holder And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Installation:

Insert the power window (4) into the door.

Tighten down nuts (3).

Tightening torque 51 33 1AZ .

Attach the cable to the holder (2).

Connect plug connection (1).

Fig 2: Power Window, Plug Connection, Holder And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.