51 43 201 Removing and installing or replacing trim for roof pillar at front (A-pillar), left or right

WARNING: This page is about a different variant/trim than selected.

WARNING: Vehicles with head airbags:

Read and comply with SAFETY INFORMATION for working on vehicles with airbag systems.

IMPORTANT: Do not use any sharp-edged tools to remove the trim panels (risk of damage to head airbag).

Removal:

Release trim panel (1) from clips (2) and detach upwards out of clamp (3).

Unlock and disconnect associated plug connections, according to the equipment.

Fig 1: Releasing Trim Panel From Clips

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement (depending on equipment):

Remount TWEETER .

Installation:

Preassemble clips (2) and clamp (3) on trim panel (1).

Guides (4) must not be damaged, replace trim panel (1) if required.

Fig 2: Trim Panel, Guides, Clips And Clamp

Courtesy of BMW OF NORTH AMERICA, INC.

Feed in and engage trim panel (1).

Make sure that it is seated correctly on edge protection (2).

Fig 3: Engaging Trim Panel

Courtesy of BMW OF NORTH AMERICA, INC.