51 71 096 Removing and installing/replacing the automatic air flap control

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Removal:

Unfasten plug connection (1) and disconnect.

Unfasten cable strap (2).

Fig 1: Cable Strap And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Feed out the air flap control (2) in area (3) and remove the support.

Fig 2: Air Flap Control And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Feed in air flap control (2) and suspend in the support in area (3).

Tighten down screws (1).

Tightening torque 51 71 6AZ .

Fig 3: Air Flap Control And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Connect the connector (1).

Attach cable clip (2).

Fig 4: Cable Strap And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.