51 12 070 Replacing the center spoiler on rear bumper panel

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Removal:

Release catches (1) and remove spoiler (2).

Fig 1: Catches And Spoiler

Courtesy of BMW OF NORTH AMERICA, INC.

When replacing, swap over the following parts:

Installation:

Position spoiler (2) and engage latch mechanisms (1).

NOTE: Latch mechanisms (1) on spoiler and bumper panel must not be damaged.

Fig 2: Catches And Spoiler

Courtesy of BMW OF NORTH AMERICA, INC.