51 11 060 Removing and installing/replacing support for front lower bumper panel

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

REMOVAL:

Release screws (1).

Detach holder of air duct (2) upwards out of support (3).

Remove support (3).

Fig 1: Air Duct, Support, And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

INSTALLATION:

Insert support (3).

Attach holder of air duct (2) in support (3).

Tighten down screws (1).

Tightening torque 51 11 3AZ .

Fig 2: Air Duct, Support, And Screws

Courtesy of BMW OF NORTH AMERICA, INC.