13 62 590 Replacing charging pressure sensor (upstream of throttle valve)

WARNING: This page is about a different car, the 2018 MINI Cooper, 2017 MINI Cooper, 2016 MINI Cooper, 2015 MINI Cooper, and 2014 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks:

Remove THROTTLE BODY .

Removal:

Release screw (1).

Remove charging pressure sensor (2).

Fig 1: Charging Pressure Sensor And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Preparation for installation:

Check sealing ring of charging pressure sensor and replace in case of damage.

Part: Sealing ring

Prior to installation, apply a thin coat of anti-friction agent to sealing ring of charge-air pressure sensor.

Installation:

Install charging pressure sensor (2).

Tighten down screw.

Tightening torque 13 62 4AZ .

Fig 2: Charging Pressure Sensor And Screw

Courtesy of BMW OF NORTH AMERICA, INC.