13 62 560 Remove and install/replace hot film air mass meter

WARNING: This page is about a different car, the 2018 MINI Cooper, 2017 MINI Cooper, 2016 MINI Cooper, 2015 MINI Cooper, and 2014 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Removal:

Unlock connector (1) and pull off.

Unfasten screws (2).

Remove the hot film air mass meter (3).

Fig 1: Hot Film Air Mass Meter, Connector And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Install hot film air mass meter (3).

Tighten down screws (2).

Tightening torque 13 62 6AZ .

Attach connector (1).

Connector (1) must engage audibly.

Fig 2: Hot Film Air Mass Meter, Connector And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement only:

Reset the adaptation values for the air mass system with the MINI diagnosis system.