Adjusting selector lever (8-speed, AISIN GA8F22AW) (Cooper Clubman base AWD, Cooper Clubman S, Cooper Clubman JCW)
IMPORTANT:
An incorrectly adjusted gearshift mechanism can result in tooth meshing noises be transmitted into the passenger compartment.
Preliminary work needed:
- Shift selector lever into "P" position.
- Remove INTAKE SILENCER HOUSING .
Removal:
Remove screw (1).
The head piece for tolerance compensation must be easily moveable before installation.
Release ball socket (1) from ball pivot.
Release the cable (2) from the support angle.
Position "P" of lever (1) is the rearmost locked position.
Installation:
Press in cable (2) into the support angle.
Ensure cable counter support audibly engages.
Press on ball socket (1) onto ball pivot.
Tighten screw (1).
Tightening torque 24 51 1AZ .
Required follow-up work:
- Install INTAKE SILENCER HOUSING .