Remove and install support bearing for shock absorber (EDC), rear (Cooper)

Special tools required: 

• 33 0 040

Preliminary work needed: 

• Remove rear SHOCK ABSORBER .

Removal: 

Release adapter plate (2) from support bearing.

Disconnect connector (1) from shock absorber.

Remove adapter plate (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Release nut (1) with special tool 33 0 040, reversible ratchet with extension and socket SW10.

Remove spring strut mounting (2).

Impact

screwdrivers are prohibited!

Risk of damage inside the shock absorber! 

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Courtesy of BMW OF NORTH AMERICA, INC.

Fit support bearing (2).

Part  : Replace nut (1).

Tighten down nut (1) with special tool 33 0 040, reversible ratchet with extension, socket SW10 and torque wrench with ring wrench attachment SW21.

Tightening torque 33 52 3AZ .

Impact screwdrivers are prohibited!

Risk of damage inside the shock absorber! 

Installation note: 

Make sure cable routing (1) is in the correct position. See figure!

Courtesy of BMW OF NORTH AMERICA, INC.

Connect connector (1) to shock absorber.

Fit adapter plate (2) on support bearing and engage.

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: 

• Install rear SHOCK ABSORBER .