Adjusting rear axle (Cooper)

Special tools required:

32 4 200

NOTE: A camber change always means a track change as well. The camber must therefore be adjusted first.
If camber and toe-in are not adjustable within setpoint range: Troubleshooting at rear axle.

Adjusting camber:

Replace the eccentric screw (1) and nut and tighten to 5 Nm prior to setting.

G11648126

Courtesy of BMW OF NORTH AMERICA, INC.

Turn screw (1) and adjust camber to setpoint value.

G11648127

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten nut (1).

Parts : Replace nut.

Tightening torque 33 32 2AZ .

G11648126

Courtesy of BMW OF NORTH AMERICA, INC.

Adjusting track:

Replace the screws (1) and (2) and tighten to 5 Nm prior to setting.

Mount special tool 32 4 200 on screw (2).

Turn special tool 32 4 200 and adjust toe-in to setpoint value.

G11648129

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down screws (1).

Tightening torque 33 32 5AZ .

G11648130

Courtesy of BMW OF NORTH AMERICA, INC.