Removing and installing/replacing the controller drive of the defroster flap
Preliminary work needed:
- Remove right GLOVE COMPARTMENT .
Removal:
Disengage and remove air duct (1) on heating and air-conditioning unit.
Unscrew the screws (1).
Unfasten plug connection (2) and disconnect.
Remove actuator drive (3).
Installation:
NOTE:
Make sure actuator drive (3) is correctly fitted.
Position actuator drive (3) correctly.
Join and lock plug connection (2).
Tighten down screws (1).
Position air duct (1) correctly and engage at heating and air-conditioning unit.
NOTE:
Ensure the air duct (1) is fitted correctly and securely.
IMPORTANT:
Servomotors must be readdressed in the event of replacement!
Addressing can only be carried out with the BMW diagnostic system.
Service functions:
- Body
- Heating/air conditioning function
- Flap motors
- Readdress flap motors
Required reworking:
- Install right GLOVE COMPARTMENT .