61 31... Removing and installing (replacing) the driving dynamics control

WARNING: This page is about a different car, the 2019 MINI Cooper, 2018 MINI Cooper, 2017 MINI Cooper, 2016 MINI Cooper, and 2015 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Removal:

Unclip bezel with driving dynamics control (2) towards the top.

Fig 1: Unclipping Bezel With Driving Dynamics Control Towards Top

G11789586

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and disconnect connector on driving dynamics control (1).

Fig 2: Disconnecting Connector On Driving Dynamics Control

G11789587

Courtesy of BMW OF NORTH AMERICA, INC.

Detach retaining ring with bellows (1) from bezel with driving dynamics control (2).

Fig 3: Detaching Retaining Ring With Bellows

G11789588

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

NOTE: The clamps on the holder (3) must not be damaged or missing.
Detents (1) on the bezel (2) must not be damaged or missing.

Fig 4: Locating Clamps On Holder

G11789589

Courtesy of BMW OF NORTH AMERICA, INC.

Insert retaining ring with bellows (3) into bezel with driving dynamics control (2).

NOTE: The guide lug (1) must snap into place in the guide.

Fig 5: Inserting Retaining Ring With Bellows Into Bezel

G11789590

Courtesy of BMW OF NORTH AMERICA, INC.

Connect connector (1) to driving dynamics control.

Fig 6: Disconnecting Connector On Driving Dynamics Control

G11789587

Courtesy of BMW OF NORTH AMERICA, INC.

Clip in bezel with driving dynamics control (2) by pushing it down.

Fig 7: Locating Clip In Bezel With Driving Dynamics Control

G11789592

Courtesy of BMW OF NORTH AMERICA, INC.