LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2019 >> Cooper Clubman S ALL4, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 95 (General Electrical System - Repair -- F55) >> Battery >> Notes for disconnecting and connecting the vehicle battery

Notes for disconnecting and connecting the vehicle battery

WARNING: This page is about a different car, the 2019 MINI Cooper, 2018 MINI Cooper, 2017 MINI Cooper, 2016 MINI Cooper, and 2015 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Observe SAFETY INSTRUCTIONS FOR HANDLING VEHICLE BATTERY .

Before disconnecting vehicle battery: 

Turn off the ignition and other electrical loads/consumers to prevent spark formation when reconnecting.

NOTE: If the ignition is not switched off when the vehicle battery is disconnected, fault memories may be set in some control units.
IMPORTANT:
  • There is a danger of mixing up battery cables: if the positive battery cable and battery ground lead are the same color and you are in doubt, follow the polarity to the vehicle battery, then mark and cover the leads
  • The on-board computer and clock may lose your data.

General notes on disconnecting the vehicle battery: 

Only lead AGM battery:

IMPORTANT: The scope of application of some systems may be restricted after an open circuit.

Personal Profiles may also be lost.

Settings or activations must be carried out, depending on the equipment specification.

For example:

Refer to the diagnostic system for further vehicle-specific information.