41 12 557 Stripping operations - Replacing luggage compartment floor, middle (tail panel removed)

WARNING: This page is about a different car, the 2019 MINI Cooper, 2018 MINI Cooper, 2017 MINI Cooper, 2016 MINI Cooper, and 2015 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Owing to the different engine variants and equipment specifications, not all the components are taken into consideration. The following list essentially represents the disassembly sequence.

Remove cross member trim panel via rear axle support

Release nuts and remove heat shield (1).

Release grommets (2).

Release the wiring harness at the attachment points (3) and tie it to the side.

Installation note:

Make sure the grommets are installed correctly. (watertightness).

Fig 1: Heat Shield, Grommets, And Wiring Harness Attachment Points

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) and remove exhaust bracket.

Tightening torque 18 20 2AZ .

Fig 2: Exhaust Bracket Screw

Courtesy of BMW OF NORTH AMERICA, INC.