12 14 600 Replacing the knock sensor (B36, B38)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2019 MINI Cooper, 2018 MINI Cooper, 2017 MINI Cooper, 2016 MINI Cooper, and 2015 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove INTAKE PLENUM .

Removal:

Unlock connector (1) and pull off.

Release screw (2).

Remove knock sensor (3).

Fig 1: Knock Sensor, Connector And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Preparation for installation:

Clean contact surface of knock sensor on engine block.

Installation:

Install knock sensor (3).

Tighten screw (2).

Observe tightening torque without fail!

Tightening torque 13 62 3AZ .

Attach connector (1).

Connector (1) must engage audibly.

Fig 2: Knock Sensor, Connector And Screw

Courtesy of BMW OF NORTH AMERICA, INC.