11 37 020 Removing and installing/replacing servomotor for eccentric shaft (B36A/B38A)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2019 MINI Cooper, 2018 MINI Cooper, 2017 MINI Cooper, 2016 MINI Cooper, and 2015 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove ACOUSTIC COVER

Removal:

Unlock and disconnect the connector (1).

Fig 1: Locating Connector

G11645311

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Fig 2: Locating Screws

G11645312

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT:

Risk of damage to intermediate shaft.

Release intermediate shaft:

Turn servomotor (1) in direction of arrow to the left by means of reversible ratchet (2) and 4 mm hexagon socket wrench.

Do not turn shaft beyond end stop.

Fig 3: Turning Servomotor

G11645313

Courtesy of BMW OF NORTH AMERICA, INC.

Remove actuator drive.

Installation:

Detach and replace gasket (1) in direction of arrow.

Fig 4: Replacing Gasket

G11645314

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Press-in gasket (1) up to limit position on housing.

Fig 5: Pressing-In Gasket

G11645315

Courtesy of BMW OF NORTH AMERICA, INC.

Insert controller drive (1) as far as the gearing.

Screw in controller drive (1) using reversible ratchet (2) and 4 mm hexagon socket wrench in direction of arrow up to limit position.

Fig 6: Screwing-In Controller Drive Using Reversible Ratchet And Hexagon Socket Wrench

G11645316

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down screws (1).

Tightening torque: 11 37 2AZ .

Fig 7: Locating Screws

G11645312

Courtesy of BMW OF NORTH AMERICA, INC.

Connect the connector (1).

Fig 8: Locating Connector

G11645311

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work:

Check function of Digital Engine Electronics.