24 00 018 Adjusting selector lever (AISIN F21FT)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2019 MINI Cooper, 2018 MINI Cooper, 2017 MINI Cooper, 2016 MINI Cooper, and 2015 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
An incorrectly adjusted gearshift mechanism can result in tooth meshing noises be transmitted into the passenger compartment.
Necessary preliminary tasks:
- Move selector lever into "P" position
- Remove INTAKE FILTER HOUSING
Removal:
Release screw (1).
The head piece for tolerance compensation must be easily moveable before installation.
Release ball socket (1) from ball stud.
Release cable (2) from support angle.
Position "P" of selector lever (1) is the rearmost locked position.
Installation:
Press in cable (2) into support angle.
Ensure cable counter support audibly engages.
Press on ball socket (1) onto ball stud.
Tighten screw (1).
Tightening torque 24 51 1AZ .