31 35 000 Removing and installing/replacing front anti-roll bar

Removal: 

Fig 1: Anti-Roll Bar Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) from anti-roll bar.

• Lower FRONT AXLE SUPPORT .

Fig 2: Heat Shield And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Loosen screws (1).

Remove heat shield (2).

Fig 3: Anti-Roll Bar With Retaining Bracket On Front Axle

Courtesy of BMW OF NORTH AMERICA, INC.

Remove anti-roll bar (1) with retaining bracket from front axle.

Installation: 

Fig 4: Remount Retaining Bracket On Anti-Roll Bar

Courtesy of BMW OF NORTH AMERICA, INC.

If necessary, remount retaining bracket (1) on new anti-roll bar (2).

Fig 5: Anti-Roll Bar With Retaining Bracket On Front Axle

Courtesy of BMW OF NORTH AMERICA, INC.

Place anti-roll bar (1) on front axle and align.

Part:  Replace screws.

Screw screws into retaining bracket from below and tighten hand-tight.

Place heat shield (2) in position.

Tighten down screws (1).

Tightening torque 32 00 2AZ .

Fig 6: Heat Shield And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

• Raise FRONT AXLE SUPPORT .

Fig 7: Anti-Roll Bar Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten screws (1) of anti-roll bar.

Tightening torque 31 35 3AZ .