34 00 009 Checking brakes on test stand
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2019 MINI Cooper, 2018 MINI Cooper, 2017 MINI Cooper, 2016 MINI Cooper, and 2015 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Check tires for damage
- Check tire treads
- Check tire pressure
- The brakes must be at normal operating temperature. To that end, warm up and dry off the brake discs by braking the vehicle a few times.
IMPORTANT:
- Only brake test stands with test speeds of 2.5-6 km/h may be used.
- On vehicles equipped with Dynamic Stability Control (DSC), the system needs to be deactivated!
- The warning light for the Dynamic Stability Control (DSC) inside the instrument cluster has to be illuminated!
Front brakes:
- Drive the front wheels of the vehicle onto the brake test stand
- Place the selector lever in selector lever position "N"
- Start the brake test stand
- Press service brake pedal
- Read off maximum brake power on left/right
Rear brakes:
- Drive the rear wheels of the vehicle onto the brake tester
- Place the selector lever in selector lever position "N"
- Start the brake test stand
- Press service brake pedal
- Read off maximum brake power on left/right
Parking brake:
- Drive the rear wheels of the vehicle onto the brake tester
- Place the selector lever in selector lever position "N"
- Start the brake test stand
- Operate parking brake lever and read out maximum brake force left/right
IMPORTANT:
A terminal change needs to be carried out after finishing the checks!
After the terminal change, all indicator lights go out!
After the terminal change, all indicator lights go out!