LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2019 >> Cooper Clubman S ALL4, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Mini Technical Data -- Cooper S & JCW (F55, F56)) >> Brakes >> Front Brakes >> 34 11 Front Brakes

34 11 Front Brakes

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2019 MINI Cooper, 2018 MINI Cooper, 2017 MINI Cooper, 2016 MINI Cooper, and 2015 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
FRONT BRAKES SPECIFICATION

Attention!
New brake pads may only be installed if the brake disk thickness is greater than the minimum brake disc thickness.
Minimum brake disc thickness during general inspection (GI):
Nominal size thickness minus 2.4 mm
(Not applicable to perforated brake discs)
Perforated brake discs:
Nominal size thickness minus 1.6 mm
Depending on:
  • Engine type
  • Transmission version
  • Equipment specification (e.g. maximum load increase, chassis official-use, national version, etc.)

different brake discs can be fitted
The brake discs must always be assigned by way of the relevant vehicle identification number.
   
Thickness difference in the friction surfaces of the brake disc Max. mm 0.01
Nominal size (diameter x thickness) mm 280x22
Nominal size (diameter x thickness) mm 294x22
Minimum brake disc thickness stamped on brake disc chamber mm 20.4
Pad wear warning from remaining brake pad thickness mm 3.7