32 21 151 Replacing left or right track rod end

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2019 MINI Cooper, 2018 MINI Cooper, 2017 MINI Cooper, 2016 MINI Cooper, and 2015 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If the track rod end to track rod screw connection is released, it is necessary after reinstallation to carry out a chassis/wheel alignment check.

Necessary preliminary tasks :

Remove FRONT WHEEL .

Removal :

Fig 1: Track Rod And Slacken Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Slacken nut (1).

Release track rod (2) from swivel bearing.

Fig 2: Track Rod End And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Mark thread depth of track rod end to simplify subsequent adjustment of front axle.

Release screw (1).

Unscrew track rod end (2).

Counterhold track rod with open-end spanner if necessary.

Installation :

Check GAITER for damage and replace if necessary.

Screw track rod end onto tie rod up to marking.

Counterhold track rod with open-end spanner if necessary.

Fig 3: Track Rod End And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten screw (1).

Tightening torque 32 21 2AZ .

Fig 4: Track Rod And Slacken Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Keep track rod end to swivel bearing connection clean and free from oil and grease.

Insert track rod (2) into swivel bearing.

Part : Replace nut (1).

Tighten nut (1).

Tightening torque 32 21 1AZ .

Required follow-up work :

Install FRONT WHEEL .
Carry out WHEEL ALIGNMENT PROCEDURE .