52 26 311 Removing and installing/replacing lock for left or right rear seat backrest

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2019 MINI Cooper, 2018 MINI Cooper, 2017 MINI Cooper, 2016 MINI Cooper, and 2015 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT:

Microencapsulated screws must be coated with Loctite if they are to be reused
Screw connection must be completed within 20 min. (start of hardening)
Microencapsulated screws must not be retightened
Thread of nut must be cleaned beforehand in event of repeated use

Removal:

Unclamp cover (1) and remove.

Fig 1: Removing Cover

G11649687

Courtesy of BMW OF NORTH AMERICA, INC.

Release welt in area (1).

Fig 2: Welt Releasing Area

G11649688

Courtesy of BMW OF NORTH AMERICA, INC.

Press seat cover and upholstery slightly to one side.

Unclip cover (1) by releasing latch mechanisms (2) and remove.

Fig 3: Latch Mechanisms And Cover

G11649689

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove the lock (2).

Fig 4: Lock And Screws

G11649690

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Position lock (2).

Tighten down screws (1).

Tightening torque 52 26 1AZ .

Fig 5: Lock And Screws

G11649690

Courtesy of BMW OF NORTH AMERICA, INC.

Clip in cover (1).

Ensure that latch mechanisms (2) correctly engage.

Fig 6: Latch Mechanisms And Cover

G11649689

Courtesy of BMW OF NORTH AMERICA, INC.

Secure welt in area (1).

Fig 7: Welt Releasing Area

G11649688

Courtesy of BMW OF NORTH AMERICA, INC.

Clip in cover (1).

Fig 8: Installing Cover

G11649694

Courtesy of BMW OF NORTH AMERICA, INC.