52 26 022 Removing and installing/replacing striker for left or right rear seat backrest
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2019 MINI Cooper, 2018 MINI Cooper, 2017 MINI Cooper, 2016 MINI Cooper, and 2015 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
- Microencapsulated screws must be coated with Loctite if they are to be reused
- Screw connection must be completed within 20 min. (start of hardening)
- Microencapsulated screws must not be retightened
- Thread of nut must be cleaned beforehand in event of repeated use
Necessary preliminary tasks:
- Remove LUGGAGE COMPARTMENT WHEEL ARCH PANEL
- Fold down backrest
Removal:
Release screws (1).
Remove striker (2).
Installation:
Position striker (2).
Tighten down screws (1).
Tightening torque 52 26 3AZ .