52 26 011 Removing and installing/replacing backrest for left rear seat

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2019 MINI Cooper, 2018 MINI Cooper, 2017 MINI Cooper, 2016 MINI Cooper, and 2015 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT:

Microencapsulated screws must be coated with Loctite if they are to be reused
Screw connection must be completed within 20 min. (start of hardening)
Microencapsulated screws must not be retightened
Thread of nut must be cleaned beforehand in event of repeated use

Necessary preliminary work:

Remove REAR SEAT

Removal:

Release screw (1) of the end fitting (2).

Remove end fitting (2).

Fig 1: End Fitting And Screw

G11649657

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and fold down both rear seat backrests.

Lift off cover (1).

Fig 2: Cover

G11649658

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Take off holder (2).

Fig 3: Holder And Screw

G11649659

Courtesy of BMW OF NORTH AMERICA, INC.

Put up rear seat backrest (1) at an angle of approx. 45 °.

Feed out frame (2) of rear seat backrest (1) upwards out of mounting (3) firstly at the center.

Feed out frame (2) of rear seat backrest (1) out of guide (4) in direction of center of vehicle.

Fig 4: Removing Rear Seat Backrest Frame

G11649660

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Feed in rear seat backrest (1) into guide (4) at an angle of approx. 45 °.

Feed in frame (2) of rear seat backrest (1) into mounting (3).

Fig 5: Removing Rear Seat Backrest Frame

G11649660

Courtesy of BMW OF NORTH AMERICA, INC.

Feed in holder (2).

Tighten screw (1).

Tightening torque 52 26 2AZ .

Fig 6: Holder And Screw

G11649659

Courtesy of BMW OF NORTH AMERICA, INC.

Clip in cover (1).

Fold up and lock both rear seat backrests.

Fig 7: Cover

G11649658

Courtesy of BMW OF NORTH AMERICA, INC.

Mount end fitting (2).

Tighten screw (1) of the end fitting (2).

Tightening torque 72 11 22AZ .

Fig 8: End Fitting And Screw

G11649657

Courtesy of BMW OF NORTH AMERICA, INC.