52 15 050 Remove or install left or right thigh support from/on the front seat (sport seat)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2019 MINI Cooper, 2018 MINI Cooper, 2017 MINI Cooper, 2016 MINI Cooper, and 2015 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
- Microencapsulated screws must be coated with Loctite if they are to be reused
- Screw connection must be completed within 20 min. (start of hardening)
- Microencapsulated screws must not be retightened
- Thread of nut must be cleaned beforehand in event of repeated use
Removal:
Adjust thigh support (1) towards the front.
Lever out welt (2) of seat cover out of bracket (3).
Release screws (1).
Detach thigh support (2) towards the front and remove.
Version with seat heating only:
Unfasten plug connection (1) and disconnect.
Remove thigh support (2).
Installation:
Version with seat heating only:
Position thigh support (2) and connect connector (1).
Feed in thigh support (1) with guides (2) into corresponding openings on seat frame (3).
Tighten down screws (1).
Attach welt (2) of seat cover in bracket (3).