11 78 510 Removing and installing/replacing control sensor (B48, B46)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2019 MINI Cooper, 2018 MINI Cooper, 2017 MINI Cooper, 2016 MINI Cooper, and 2015 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

11 7 020

WARNING: Risk of burning !

Only perform these tasks after exhaust system has cooled down.

Necessary preliminary tasks:

Remove CLEAN AIR PIPE

Removal:

Unclip connector (1) of control sensor from holder.

Unlock and disconnect the connector (1) of the control sensor.

Release cable of control sensor from bracket inside the marked area.

Fig 1: Control Sensor Connector

Courtesy of BMW OF NORTH AMERICA, INC.

Slightly bend up heat protection film (1).

Release control sensor (2) with special tool 11 7 020 .

Fig 2: Releasing/Installing Control Sensor With Special Tool (11 7 020)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Installation note:

If an oxygen sensor is reused, thinly and evenly coat only the thread with NEVER-SEEZ COMPOUND 4.3 .

The part of the oxygen control sensor which projects into the exhaust branch (sensor ceramic) must not be cleaned or come into contact with lubricant.

Screw in control sensor (2) and tighten with special tool 11 7 020 .

Tightening torque: 11 78 1AZ .

Properly install heat protection film (1).

Fig 3: Releasing/Installing Control Sensor With Special Tool (11 7 020)

Courtesy of BMW OF NORTH AMERICA, INC.

Connect connector (1) of control sensor and clip into holder.

Clip in cable of monitoring sensor on bracket inside the marked area.

Fig 4: Control Sensor Connector

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work:

Check function of DME.