LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2019 >> Cooper Clubman S ALL4, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Heating And Air Conditioning - Repair (F55, F56)) >> HVAC Unit, Control Panel, Blowers, HVAC Sensors, Blending Flap Actuator >> 64 11 872 Removing and installing/replacing the controller drive for the mixed air flap (right)

64 11 872 Removing and installing/replacing the controller drive for the mixed air flap (right)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2019 MINI Cooper, 2018 MINI Cooper, 2017 MINI Cooper, 2016 MINI Cooper, and 2015 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks: 

Removal: 

Unfasten plug connection (1) and disconnect.

Unfasten screws (2).

Remove actuator drive (3).

Fig 1: Actuator Drive, Plug Connection, And Screws
G11149005Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Position actuator drive (3) correctly.

Tighten down screws (2).

Join and lock plug connection (1).

Fig 2: Actuator Drive, Plug Connection, And Screws
G11149005Courtesy of BMW OF NORTH AMERICA, INC.
IMPORTANT:

Servomotors must be readdressed in the event of replacement!

Addressing can only be carried out with the BMW diagnosis system.

Service functions:

  • Body
  • Heating/air conditioning function
  • Flap motors
  • Readdress flap motors
scientia non olet · About LEMON Manuals