64 11 868 Removing and installing/replacing the controller drive of the defroster flap

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2019 MINI Cooper, 2018 MINI Cooper, 2017 MINI Cooper, 2016 MINI Cooper, and 2015 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove RIGHT GLOVE BOX

Removal:

Disengage and remove air duct (1) on heating and air-conditioning unit.

Fig 1: Air Duct Of Heating And Air-Conditioning Unit

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Unfasten plug connection (2) and disconnect.

Remove actuator drive (3).

Fig 2: Actuator Drive, Plug Connection, And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

NOTE: Make sure actuator drive (3) is correctly fitted.

Position actuator drive (3) correctly.

Join and lock plug connection (2).

Tighten down screws (1).

Fig 3: Actuator Drive, Plug Connection, And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Position air duct (1) correctly and engage at heating and air-conditioning unit.

NOTE: Ensure the air duct (1) is fitted correctly and securely.

Fig 4: Air Duct Of Heating And Air-Conditioning Unit

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT:

Servomotors must be readdressed in the event of replacement!

Addressing can only be carried out with the BMW diagnosis system.

Service functions:

Body
Heating/air conditioning function
Flap motors
Readdress flap motors