22 11 095 Removing and installing/replacing holder with rubber mount

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2019 MINI Cooper, 2018 MINI Cooper, 2017 MINI Cooper, 2016 MINI Cooper, and 2015 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary work:

Remove front UNDERBODY PROTECTION

Removal:

Attention !

Support engine with lifter.

Undo bolts (1) and remove bracket (2) with rubber mount.

Fig 1: Bracket Bolts Location

G11646013

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Fig 2: Rubber Mount Down Screws Location

G11646014

Courtesy of BMW OF NORTH AMERICA, INC.

Install holder (1) with rubber mount.

Tighten down screws (2).

Tightening torque 22 11 4AZ .

Tighten screw (3).

Tightening torque 22 11 5AZ .

Required follow-up work:

Install front UNDERBODY PROTECTION