Replacing transmission input speed sensor (6-speed, AISIN GA6F21AW)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
AFTER COMPLETION OF WORK, CHECK TRANSMISSION OIL LEVEL
.
Make a note of drained ATF quantity.
Make a note of drained ATF quantity.
IMPORTANT:
Use only the approved automatic transmission oil: ATF6 (BMW/MINI part number 83 22 2 355 599).
Otherwise the automatic transmission may incur extensive damage!
Do not drain oil before the transmission has cooled down.
Otherwise the automatic transmission may incur extensive damage!
Do not drain oil before the transmission has cooled down.
Necessary preliminary work:
- Remove HYDRAULIC CONTROL UNIT .
Removal:
Remove screw (1).
Remove sensor (2).
Installation:
Install sensor (2) and fasten with screw (1).
IMPORTANT:
Coat sealing ring with clean transmission oil.
Tightening torque: 24 35 1AZ .
Required follow-up work:
- Install HYDRAULIC CONTROL UNIT .