Replace left radial shaft seal on differential (GS6-58BG) (Cooper base)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

230120
23 0 370
2 409 230

Preliminary work needed:

Remove LEFT OUTPUT SHAFT only at transmission end and hang up

Removal:

Preparing special tool 23 0 120:

Distance (1) <1 mm.

Courtesy of BMW OF NORTH AMERICA, INC.

Insert special tool 23 0 120 in the radial shaft seal as far as stop. The support brackets spread by turning the nuts (2). Then screw in screw (3) and detach radial shaft seal.

IMPORTANT: Risk of damage:
Damage to the transmission housing will result in oil leaks!

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

NOTE: Coat sealing lips of radial shaft seal with transmission oil.

Drive radial shaft seal with special tool 2 409 230 into the transmission housing until sealing ring is flush with differential.

Check TRANSMISSION OIL LEVEL and check for leak.

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work:

Install LEFT OUTPUT SHAFT .

IMPORTANT: After completion of work, check TRANSMISSION OIL LEVEL .
The vehicle must be parked on a level surface in the 095 workshop to check the transmission oil level.
Use only the approved transmission oil: MINI transmission oil MTF 2 or MTF 3.
Failure to comply with this instruction will result in serious damage to the transmission.

Recycling:

Catch and dispose of leakage transmission oil.

Observe country-specific waste disposal regulations