REP-TAT-P-5434-02 Installing the trim panel for the rear case
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
Prerequisite
The convertible top is opened half way.
- In the center, install four new clips (1) and install one lock nut (2) each on the left and right sides.
Parts: Clips and lock nuts.
- Clip in the trim panel for the case (1) from below in the arrow direction.
- Insert the trim panel for the case (1) and with the help of the special tool, 2 298 505
guide it into the trim (2) on the left and right.
- Replace the bolts (1) on the left and right.
Parts: Screw
TIGHTENING TORQUE SPECIFICATION
| Trim panel for case in rear |
| 1.2 Nm |