REP-TAT-P-5434-02 Installing the convertible top brace bearing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
Follow-up work
- Close LOADING AID
- Insert the convertible top brace bearing (4).
- Screw in screws (1), (2) and (3), do not tighten yet.
- Align the convertible top brace bearing (4) with the highlighted attachment points.
- Tighten down screws (1) and (2).
Parts: screw
TIGHTENING TORQUE SPECIFICATIONConvertible top brace bearing to body Hexagon screw Replace screw. Joining torque 20.5 Nm Angle of rotation 90° Torx bolt Replace screw. Joining torque 9.5 Nm Angle of rotation 90° - Tighten down screw (3).
Parts: screw
TIGHTENING TORQUE SPECIFICATIONConvertible top brace to convertible top brace support Replace screw. Joining torque 9.5 Nm Angle of rotation 90° - Insert the protective cap (1).
- Right side only:
Clip in the connector (2) into the convertible top brace bearing (3).
Connect connector (1).