61 31 117 Removing and installing/replacing power window switch (driver's/passenger's side)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2019 MINI Cooper, 2018 MINI Cooper, 2017 MINI Cooper, 2016 MINI Cooper, and 2015 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 327

IMPORTANT: Carry out the following operation carefully so as to avoid damaging the door trim panel and switch.
If necessary, tape off working area.

Removal:

Lever power window switch (1) out of armrest (2) in direction of arrow using special tool 00 9 327 .

Disconnect connector underneath and remove power window regulator switch (1).

Fig 1: Removing Power Window Regulator Switch

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Release latch mechanisms on both sides and feed power window switch (1) out of trim (2).

Join switch replacement part for power window regulator (1) in cover (2).

NOTE: Ensure latch mechanism of switch for power window regulator (1) in cover (2) is correct.

Fig 2: Locating Power Window Regulator Switch

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

NOTE: The guide (1) and latch mechanisms (2) on the trim (3) must not be damaged or missing.

Fig 3: Locating Trim Guide And Latch Mechanisms

Courtesy of BMW OF NORTH AMERICA, INC.

Connect connector.

Join power window regulator switch (1) in armrest (2) in direction of arrow.

NOTE: Make sure that the power window switch is correctly seated in the armrest.

Fig 4: Installing Power Window Regulator Switch Into Armrest

Courtesy of BMW OF NORTH AMERICA, INC.