61 62 060 Removing and installing/replacing rear wiper motor

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2019 MINI Cooper, 2018 MINI Cooper, 2017 MINI Cooper, 2016 MINI Cooper, and 2015 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove WIPER ARM FOR REAR WIPER
Remove TRIM FOR TAILGATE AT BOTTOM

Removal:

Unlock hose pipe (1) and disconnect.

Unlock and disconnect connector (2).

Release screws.

Pull wiper motor (3) out of grommet (4).

Fig 1: Locating Wiper Motor Grommet Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

NOTE: Check grommet (4) of wiper pivot for signs of damage, replace if necessary.

Join wiper motor (3) in grommet (4).

Tighten down screws (3).

Tightening torque 61 62 2AZ .

Connect connector (2).

Connect hose pipe (1).

Fig 2: Locating Wiper Motor Grommet Screws

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Ensure fit and latch mechanism of hose pipe (1) are correct.

Required follow-up work:

Adjust WASHER JET .