Removing and installing/replacing lower part of steering shaft (Cooper Convertible)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Do not turn the steering wheel once the steering shaft has been detached from the steering box/steering column! If the lower part of the steering shaft is separated from the steering box/steering column, the steering column switch cluster may be damaged when the steering wheel is turned.
Removal:
Release and remove nut (1).
Release nuts (2) 1 rotation. (Do not remove!)
Remove cover (3).
NOTE:
For purposes of clarity, graphic does not show side footwell trim.
Side footwell trim must not be disassembled!
Remove screw (1).
Swivel out bottom steering shaft universal joint (2) from steering gear.
Release clamping bolt (1).
Release steering shaft (2) from steering column.
Installation:
Installation note:
- When steering shaft is to be reused, clean both threads in steering shaft to remove all remnants of screw locking agent.
- Clamping bolt must rest in groove of steering column.
Slide steering shaft (2) onto steering column.
Part: replace screw (1).
Tighten screw (1).
Tightening torque 32 31 3AZ .
Swivel universal joint (2) onto steering gear.
Part: replace screw (1).
Tighten screw (1).
Tightening torque 32 31 2AZ .
Align cover (2).
Tighten cap nuts (1).
Required follow-up work:
- Turn steering wheel in both directions to the stop. The airbag checklight must not light up in the process.