Additional work for camber correction (Cooper Convertible)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The camber adjustment is performed only with the replacement of the SWIVEL BEARING . There are 3 different swivel bearings for this!

Attention!

Changes in axle geometry caused by accidents must under no circumstances be rectified by camber adjustment!

NOTE: The swivel bearing may only be replaced if the camber is outside the specified tolerance after toe adjustment.

Preliminary work needed:

Adjust TOE-IN .

Check camber values; if necessary, replace SWIVEL BEARING with over- or under-dimension variant.

NOTE: The camber correction swivel bearings are only identifiable via MINI part number (1).

Also refer to the applicable BMW/MINI Parts Catalog!

These camber correction swivel bearings are used to correct the camber values by 30 min. To be used only if the tolerance values are exceeded or undershot!

After setting:

Check directional stability of car; if necessary, repeat TOE-IN .