Removing and installing/replacing front anti-roll bar (Cooper Convertible)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
Removal:
Release screws (1) from anti-roll bar.
- Lower front AXLE SUPPORT .
Loosen screws (1).
Remove heat shield (2).
Remove anti-roll bar (1) with retainer from front axle.
Installation:
If necessary, remount retainer (1) on new anti-roll bar (2).
Position anti-roll bar (1) on front subframe.
Replace screws (1).
Parts : screw
Screw screws into retainer from below and tighten hand-tight.
Position heat shield (2).
Replace screws (1).
Parts : screw
Tighten down screws (1).
Tightening torque 32 00 2AZ .
- Raise front AXLE SUPPORT .
Tighten screws (1) of anti-roll bar.
Tightening torque 31 35 3AZ .