Installing and removing/replacing hydraulic valve for oil pressure control (B36 engine) (Cooper base)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Preliminary work needed:

Remove FULL-FLOW OIL FILTER .

Removal:

Unlock and disconnect the connector (1)

Remove screw (2).

G11645342

Courtesy of BMW OF NORTH AMERICA, INC.

Remove hydraulic valve (1) in arrow direction.

G11645343

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Parts : Replace O-ring (1).

Oil O-ring (1).

G11645344

Courtesy of BMW OF NORTH AMERICA, INC.

Install hydraulic valve (1) in arrow direction.

G11645345

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten screw (2).

Tightening torque: 11 00 2AZ .

Connect the connector (1).

G11645342

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work:

Install FULL-FLOW OIL FILTER .
Check engine for leaks