LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2019 >> Cooper Clubman S ALL4, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 134 (Engine - Repair (F57)) >> 11 33 Rocker/Rocker Arm With Bearing >> Removing and installing/replacing all rocker arms (B36 engine) (Cooper base)

Removing and installing/replacing all rocker arms (B36 engine) (Cooper base)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required: 

Preliminary work needed: 

IMPORTANT: Roller cam followers on intake side are subdivided into bearing classes.
Already used roller cam followers may only be reused in the same position.

Removal: 

Release roller cam followers (1) on intake side from hydraulic valve clearance compensating elements and remove.

Place all roller cam followers in order in special tool 11 4 480.

G11645154Courtesy of BMW OF NORTH AMERICA, INC.

Release roller cam followers (1) on exhaust side from hydraulic valve clearance compensating elements and remove.

Place all roller cam followers in order in special tool 11 4 480.

G11645154Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Classification of roller cam follower intake.

The tolerance classes are marked according to the illustration in numbers from 1 to 5.

Standard:

Number 3. standard.

Number 2. slow idle.

Number 4. fast idle.

G11645156Courtesy of BMW OF NORTH AMERICA, INC.

In case of repair: rough idling speed.

Repair: 1

Number 1. lower engine speed in idle.

Number 5. higher engine speed in idle.

Install roller cam followers (1) on intake side.

NOTE: Ensure correct position of roller cam followers on hydraulic valve clearance compensating elements and intake valves.
G11645154Courtesy of BMW OF NORTH AMERICA, INC.

Install roller cam followers (1) on exhaust side.

NOTE: Ensure correct position of roller cam followers on hydraulic valve clearance compensating elements and exhaust valves.
G11645154Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: 

Check function of DME; if necessary, readjust uniform mixture distribution.