Removing and installing/replacing idler pulley for drive belt (B36 engine) (Cooper base)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
Preliminary work needed:
- Remove DRIVE BELT .
Removal:
Unclip end cover (1).
Loosen screw (1).
Installation:
Tighten screw (1).
Tightening torque. 11 28 2AZ .
Mount end cover (1).
Required follow-up work:
- Install DRIVE BELT .