Replacing the engagement solenoid switch (Cooper Convertible)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Preliminary work needed:

Switch off ignition.
Remove STARTER MOTOR .

Slacken nut (1).

Remove cable head (2).

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Do not twist cable head (2) when tightening, risk of short circuit to starter motor housing.
Tightening torque 12 41 1AZ .

Unscrew the screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Remove the solenoid switch (1) and the spring (2).

Detach the bolt (3).

Installation note:

Check the bolt (3) for wear and grease the bolt.

Courtesy of BMW OF NORTH AMERICA, INC.