REP-TAT-P-4133-02 Install Cross Connection
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
Further information is available.
- Install cross connection.
- Position all screws.
- Tighten down screw (1).TIGHTENING TORQUE SPECIFICATION
Bracing strut to top cross connection M8 Tightening torque 25 Nm - Tighten down screws (2).TIGHTENING TORQUE SPECIFICATION
Air duct to deformation element/cross connection M6x20 screw Tightening torque 6 Nm NOTE: RISK OF DAMAGE
Incorrect routing of the Bowden cable for the hood lock.Chafing of the coolant ventilation line, coolant loss and engine overheating.
- Route the Bowden cable of the hood lock correctly under the lock bridge.
- Hook Bowden cable in all clips.
- Make sure that the Bowden cable has no contact with the coolant ventilatin line.
- Fasten clamps (3) for hood lock Bowden cable to cross connection.
- Tighten the screws (2) on the cross connection (3).TIGHTENING TORQUE SPECIFICATION
Cross connection on support for cross connection M6x20 Tightening torque 12 Nm - If applicable, fasten the expanding rivet (1).
- Tighten down screws (2).TIGHTENING TORQUE SPECIFICATION
Cross connection on support for cross connection M6x20 Tightening torque 12 Nm - Fasten expanding rivet (1).
- Installed on the right side only on vehicles with production date as of: 12/2016
- Fasten the spray guard (1) as shown on the cross connection (2).
- Fasten the spray guard (1) with the retaining tabs (3) on the lock bridge.
- Properly mount the spray guard (1) to prevent corrosion.